Sagitter MOVING WASH 575 User Manual page 14

CANALE 8: Ciano
0 255 Ciano (0 – bianco, 255 – ciano)
CANALE 9: Magenta
0-255 Magenta (0 – bianco, 255 –magenta)
CANALE 10: Giallo
0-255 Giallo (0 - bianco, 255 – giallo)
CANALE 11: Velocità del CMY
0 Velocità massima
255 Velocità minima
CANALE 12: Macro
0-7 Off
8-15 Macro 1
16-23 Macro 2
24-31 Macro 3
32-39 Macro 4
40-47 Macro 5
48-55 Macro 6
56-63 Macro 7
64-71 Macro 8
72-79 Macro 9
80-87 Macro 10
88-95 Macro 11
95-102 Macro 12
104-111 Macro 13
112-119 Macro 14
120-127 Macro 15
CANALE 13: Ruota effetti
0 -70
1 179
180 191 Filtro frost
128-135 Macro 16
136-143 Macro 17
144-151 Macro 18
152-159 Macro 19
160-167 Macro 20
168-175 Macro 21
176-183 Macro 22
184-191 Macro 23
192-199 Macro 24
200-207 Macro 25
208-215 Macro 26
216-223 Macro 27
224-231 Macro 28
232-239 Macro 29
240-247 Macro 30
248-255 Macro 31
Full beam
Beam Shaper
14
- Movement resolution
By this function you can adjust the desired movement resolution 8 or 16 bit. Use the "UP"
and "DOWN" keys to select "ON" if you wish the 16bit high resolution or "OFF" if you
wish only 8 bit resolution and press "ENTER" to confirm or "MODE" to cancel and return
to the main menu.
Note:
If you adjust the 16 bit resolution the fixture will occupy 16 DMX channels, if you adjust
the 8 bit resolution, the fixture will be operated by only 14 DMX channels.
- Lamp On time
This option enables you to read the total number of hours that the lamp has been
powered on. Press "ENTER" or "MODE" to return to the main menu. In order to reset the
counter to 0, you have to hold the "UP" and "DOWN" button and press the "ENTER"
button.
- Power On time
By this option you can read the total number of hours that the PLML575E has been
powered on. Press "ENTER" or "MODE" to return to the main menu.
- Switch on / off the lamp
Use the "UP" and "DOWN" keys to select "ON" if you wish the switch on the lamp or
"OFF" if you wish switch off the lamp and press "ENTER" to confirm or "MODE" to cancel
and return to the main menu.
- Demo sequences
This function allows you to run a special demo-test sequences without an external
controller, which will show you some possibilities of using projector. Press "UP" and
"DOWN" keys to select the "MOD1" or "MOD2" sequences. The "MOD1" is suitable for
projections on the wall, ceilling or ground without any head movement, the "MOD2" uses
all projector functions and therefore is good for a complete introduction of the fixture.
47