Page 1
ARROW 700 WASH MOVING HEAD USER’S MANUAL sagitter.com...
Page 2
5.Arrow 700 wash - DMX Protocol Mode/Channel Type of Value Function control 1 18 16 0 - 255 proportional Pan movement by 530° Pan Fine 2 19 17 0 - 255 proportional Fine control of pan movement Tilt 3 20 18...
Page 3
Mode/Channel Type of Value Function control Colour wheel Continual positioning Open/white proportiona Deep red proportiona Deep blue proportiona Orange proportional Green proportional Light red proportional Amber proportional UV flter proportional 128-129 White proportional Positioning 130-137 Deep red step 138-145 Deep blue step 146-153 Orange...
Page 4
Mode/Channel Type of Value Function control 152-159 Macro 19 step 160-167 Macro 20 step 168-175 Macro 21 step 176-183 Macro 22 step 184-191 Macro 23 step 192-199 Macro 24 step 200 - 207 Macro 25 step 14 13 16 15 15 208 - 215 Macro 26 step...
The Arrow 700 wash is to be operated with a Osram LOK-IT! HTI 700W lamp. A relay inside of the Arrow 700 wash allows you to switch on and off the lamp via the control panel or via your DMX-controller without affecting the rest of the lighting.
7 - Control menu map Default settings=Bold print Default settings=Bold print Fixture Address DMX Address Ethernet Settings Set Ethernet Mode Disable Ethernet Ethernet Ethernet/DMX Set IP Address Default IP Address Custom IP Address Set ArtNet Universe (0 -255) Fixture information Power On Time Total Hours Resetable Hours...
Page 7
Personality User Mode User A Settings User B Settings User C Settings DMX Presetting Mode 1 Ch.1 Pan Ch.22 Dimmer Fine Set Active Mode 2 Ch.1 Pan Ch.18 Dimmer Set Active Mode 3 Ch.1 Pan Ch.24 Dimmer Fine Set Active Mode 4 Ch.1 Pan Ch.20 Dimmer...
IR Sensor (On,Off) Init Effect Positions Pan (0-225) Dimmer (0-255) Dimmer fne (0-255) Save Temperature Unit ( °C,°F) Default Setting Lamp On/Off (On,Off) Test sequences Mode 1 Pan (0-255) Tilt (0-255) Zoom (0-255) Run Test Program Mode 2 Manual Mode Preset Effect Control Pan (Position 1,...,Position 7) Dimmer (Position 1,...,Position 6)
8. Maintenance and cleaning It is absolutely essential that the fixture is kept clean and that dust, dirt and smoke-fuid residues must not build up on or within the fixture. Otherwise, the fixture‘s light-output will be signifcantly reduced. Regular cleaning will not only ensure the maximum light-output, but will also allow the fixture to function reliably throughout its life.