GE Built-In Dishwashers Use & Care Manual page 19

Setting a signal
If you want the machine to signal when the wash is complete, you can program it to do this.
The machine is set without a signal by default.
1. Switch off the dishwasher at the main switch.
2. Hold in the DELAY start button at the same time as you press the
main switch. The button flashes. Release the button.
3. Press the CYCLE button – when the Auto wash symbol lights, the
signal is activated.
4. Press the START/RESET button and the setting will be stored until next time
you want to make a change.
or Reset
1. Switch off the dishwasher with the main switch.
2. Hold in the DELAY start button at the same time as you press the
main switch. The button flashes. Release the button.
3.Press the CYCLE button – when the Auto wash symbol goes out, the
signal is deactivated.
4. Press the START/RESET button and the setting will be stored until next time
you want to make a change.
Settings
Dishwasher
19