Lighting Features; Rinse Agent; Water Temperature - GE Built-In Dishwashers Use & Care Manual

Lighting
Interior Lights
Features
The interior Halogen lights provide better visibility
for loading and unloading. They turn on when
the door is opened and turn off when the door is
latched.
Water
Temperature
Use a
A rinse agent improves dry performance,
reduces spots and prevents new film buildup
Rinse
on your dishes, glasses, flatware, cookware
Agent
and plastic. Cascade Crystal Clear
recommended rinse agent for Monogram
Dishwashers.
The rinse agent dispenser holds 4.7 oz. of rinse
agent. Under normal conditions, this will last
approximately one month. Try to keep it full,
but do not overfill.
To fill the rinse agent dispenser, make sure the
dishwasher door is fully open.
1. Compartment for main wash dishwash-
er detergent
2. Compartment for pre-wash detergent
3. Rinse aid cover
4. Detergent compartment cover
12
This dishwasher can be plumbed to either a hot or
cold water line.
Hot water line connection: For effective cleaning
and to prevent dish damage, the entering water
supply should be at least 120°F (49°C) and not
more than 140°F (60°C). You can check the water
temperature with a candy or meat thermometer.
Turn on the hot water faucet nearest the
dishwasher, place the thermometer in a glass and
let the water run continuously into the glass until
the temperature ceases to rise.
Using the Dishwasher
Do not attempt to replace the bulbs. If light bulb
replacement is necessary, please contact the
GE Answer Center for service by calling
1.800.626.2000.
Cold water line connection: The dishwasher's
water heater will bring the water temperature to
the appropriate level for cleaning.
NOTE: Most cycle times will increase when
plumbed to a cold water line.
Rotate the dispenser cap counterclockwise and
lift it out. Add rinse agent until the indicator
window shows full.
is the
®
Clean up any spilled rinse agent with a damp
cloth. Replace the dispenser cap.
The amount of rinse agent released into the final
wash can be adjusted. The factory setting is at
the midpoint. If there are rings of calcium (hard
water) spots on dishes, try a higher setting. If
there is foaming, use a lower setting.
To adjust the setting, remove the dispenser
cap; then turn the adjuster counterclockwise to
increase the amount of rinse agent or clockwise
to decrease the amount of rinse agent dispensed.
1
2
Dishwasher
3 (Rinse agent adjuster
is located under the cap)
4