Control Panel Operation - GE Built-In Dishwashers Use & Care Manual

After selecting the cycle and desired enhancements, press the START/RESET pad
6
one time to ready the dishwasher to begin the cycle. Close the door to start the
cycle or begin the DELAY HOURS countdown. When the cycle starts, the water
fill begins and approximately 60 seconds later the wash action begins.
The dishwasher will always display your last selection and enhancements.
If you don't want to change the settings, simply press the START/RESET pad
START/RESET
one time to ready the dishwasher and close the door to begin the cycle.
If you wish to change the program after starting the machince, press and hold
the START/PAUSE button for 3 seconds. Select a new program and press START/
RESET. Make sure there is detergent in the dispenser.
Once the dishwasher has finished, it only draws standby current. Should
7
POWER you wish to disconnect power, just switch off at the main power switch. (The
overflow function in the dishwasher remains active.).
Control Panel/Operation
Dishwasher
11