Control Panel Operation - GE Monogram ZBD6800 Owner's Manual

Control Panel/Operation
Dishwasher
[] Status Indicator Lights (indicatorsvary by model)
The Status display tells you what is happening while the dishwasher is in operation.
The lights will come ON, indicating the sequence of the dishwasher operation.
SENSING Displayed while the ExtraClean'" Sensor is measuring the amount of soil and
temperature of water. The dishwasher will adjust the selected cycle to achieve
optimal performance.
ADD-A-DISH Displayed during prewash, indicating that dishes added now will still be cleaned.
WASHING Displayed during prewash, main wash and rinse periods.
DRYING Displaged during HEATEDDRY.
SANITIZED Displayed when cgcle has met sanitization conditions.
CLEAN Displaged when a wash cgcle and enhancements are complete.
[81Time Remaining Displag (on some models)
During operation, the displag shows the minutes remaining until the cgcle is complete. The display
may adjust the remaining time while the Sensing light is on. The time displayed at the start of
each cgcle mag change from the factory setting as the unit customizes itself to actual home
usage. During a delag start, the display will show hours of time remaining until the cgcle starts.
[] START/RESET
START--
After selecting the cycle and desired enhancements, press the START/RESET p ad
one time to ready the dishwasher to begin the cycle. Close the door to start the
cycle or begin the DELAYSTARTcountdown. When the cgcle starts, the water fill
begins and approximately 60 seconds later the wash action begins.
The dishwasher will always display your last selection and enhancements. If you
don't want to change the settings, simply press the START/RESET pad one time
to ready the dishwasher and close the door to begin the cycle.
NOTE: If the START/RESET l ight is flashing, the cgcle has been interrupted.
Light will stop flashing after the dishwasher automatically pumps out the water.
Close the door to allow the water to pump out (this takes approximately
70 seconds). When the light stops flashing, the dishwasher can be
reprogrammed and restarted.
Also, if a power failure occurs, NORMAL and HEATEDDRYwill automatically be
programmed. Make any new selections and press the START/RESET p ad to begin
the new cycle.
RESET--
[] Clean--
Open the door slowly to prevent splash-out. Press the START/RESET p ad
to cancel the cgcle. Close the door. The dishwasher will pump out and turn off
after 70 seconds.
The CLEANlight is illuminated and a double beep will sound when the selected
cycle and enhancements are complete. You may remove the dishes at any
time. Note the high-efficiency fan will run quietly for 30 minutes to 4 hours
(depending on selected cycle) after the CLEAN light is illuminated to continue
drying the dishes. This can be stopped by opening the door and pressing
any kegpad.
NOTE:To turn off the double beep indicator (or re-activate it if it was previously
disengaged}, press the HEATEDDRYpad 5 times within 3 seconds. A triple beep
will sound to indicate the end-of-cycle beep option has been toggled.