Table of Contents
Advertisement
Installing Driver with Existing Windows NT 4.0
WARNING: If you plan to move your boot drive to a mirrored RAID 1 FastTrak
array, hard drives should NOT be connected to the FastTrak TX2000 controller
card before performing the following procedure. The FastTrak TX2000 drivers
must be loaded on the system hard drive (running under the existing hard drive
controller) before any hard drives are connected to the FastTrak TX2000
controller card.
1.
Choose "Settings" from the "Start" menu.
2.
Choose "Control Panel" from the "Settings" menu.
3.
Double-click on the "SCSI Adapters" icon, which generates the "SCSI Adapters"
dialog box.
4.
Choose "Drivers," and then press "Add."
5.
In the "Install Drivers" dialog box, press "Have Disk..."
6.
When the "Install From Disk" appears, insert the "FastTrak TX2000 Driver" diskette in
drive A:.
7.
Type "A:\NT4" in the text box window, then choose "OK."
8.
When the "Install Driver" dialog box appears, select "WinNT Promise FastTrak
TX2000 (tm) Series Controller" and then press "OK."
9.
When the "Select SCSI Adapter Option" dialog box appears, press "Install."
10. After a successful installation, the "SCSI Adapter Setup" box will show that the
"WinNT Promise FastTrak TX2000 (tm) Series Controller" has been installed.
11. Power off your system.
12. If moving the boot drive to the FastTrak card, now attach the hard drives, otherwise
reboot.
Removing the Driver from Windows NT 4.x
1.
In "Start" Button choose "Control Panel" in "Setup" group.
2.
In "Control Panel," select "SCSI Adapter," next choose "Drivers" label
3.
Choose "Remove" button.
4.
After successful removal, the "SCSI Adapter Setup" box will show that "WinNT
Promise FastTrak TX2000 (tm) Series Controller" has been removed.
FastTrak TX2000™ Series User Manual
35
Advertisement
Table of Contents
