Table of Contents
Advertisement
Installing Drivers with Existing Windows 95/98
The following three sections detail the installation of FastTrak TX2000 drivers on a system that
has Windows 95/98 already installed. If you're installing the FastTrak TX2000 drivers on a
system during a Windows 95/98 installation, see "Installing Drivers During Windows 95/98
Installation" on page 38.
Windows 98
1.
After installing the FastTrak TX2000 controller card and configuring the hard drives,
power up the system and boot Windows.
2.
The "Add New Hardware Wizard" will appear, informing you that it has found a "PCI
RAID Controller."
3.
Check the "Search for the best driver for your device" box and click the Next button.
4.
Check the "Specify a Location" box and click Next button.
5.
Type "A:\WIN9x-ME" in the text box that appears.
6.
Insert the "FastTrak TX2000 Driver" diskette in drive A:.
7.
Click on "Next." The Add New Hardware wizard will say it has found "Win9x-ME
Promise FastTrak TX2000 (tm) Series Controller".
8.
Click on "Next," and then on "Finish."
9.
Choose "Yes" when asked if you want to restart your computer. Be sure to eject the
diskette from drive A:.
Windows 95
1.
After installing the FastTrak TX2000 controller card and configuring the hard drives,
power up the system and boot Windows.
2.
The "Update Device Drive Wizard" will appear, informing you that it has found a "PCI
Mass Storage Controller."
3.
Insert the "FastTrak TX2000 Driver" diskette in drive A:.
4.
Type "A:\WIN9x-ME" in the text box, then click on "Next." Windows will inform you
that it has found the "Win95-98 Promise FastTrak TX2000 controller".
5.
Click on "Finish," and when prompted to insert the "FastTrak TX2000 Driver" diskette,
click on "OK."
6.
If a message informing you that the file "FastTrak.MPD" cannot be found, go to the
"Copy files from:" text box and type: "A:\WIN9x-ME".
7.
Choose "Yes" when asked whether you want to start your computer. Be sure to
remove the diskette from drive A:.
Confirming Driver Installation in Windows 98/95
To confirm that the driver has been properly loaded in Win 95/98, perform the following steps:
1.
Choose "Settings" from the "Start" menu.
2.
Choose "Control Panel," and then double-click on the "System" icon.
FastTrak TX2000™ Series User Manual
40
Advertisement
Table of Contents
