How To Transmit Audio/Video From Your Cable Tv Hookup - RF-Link WAVECOM Sr Owner's Manual

How to transmit audio/video from your cable TV
hookup
To transmit your cable TV channels, you must have either a VCR or a cable converter
box. If you use a VCR, follow the instructions on the previous page for transmitting
from your VCR. To use your cable converter box, follow the instruction below.
Step 1. Make sure the WAVECOM
Connect one set of audio/video (A/V) cables to the A/V jacks of the
transmitter and to the A/V jacks on the back of your cable converter box.
Be sure the yellow, red and white plugs match the yellow, red and white
jacks on both the converter box and the transmitter. If the converter box
has only one output for audio (mono sound only), connect one white plug
to that single audio output and the other to transmitter's AUDIO LEFT
jack.
Step 2. Plug one end of the provided power adapter into the back of the
WAVECOM
outlet. Turn the ON/OFF switch to ON position and indicator light should
go on.
Step 3. To view your cable signal on a nearby TV, connect coaxial cable from the
single OUT port on the cable converter box to the VHF/UHF IN port on
your TV.
Step 4. Locate and orient the transmitter according to the chapter of this manual
titled "Orienting Units for Optimal Performance."
TM
TM
Sr. transmitter and the other end into any 120-volt wall
Sr. ON/OFF switch is in the OFF position.
TM
WAVECOM Sr. owner's manual 7