How To Transmit Audio/Video From Your Satellite Receiver Or Laser Disc Player - RF-Link WAVECOM Sr Owner's Manual

How to transmit audio/video from your satellite
receiver or laser disc player
You can transmit audio/video either directly from your satellite receiver or laser disc
player, or by connecting them to your VCR. To transmit directly from your satellite
receiver or laser disc player, follow the instructions below.
Step 1. Make sure the WAVECOM
Connect one set of audio/video (A/V) cables to the A/V jacks of the
transmitter and to the AUDIO/VIDEO OUT jacks of the satellite receiver
or laser disc player. Be sure the yellow, red and white plugs match the
yellow, red and white jacks on both t he satellite receiver/laser disc player
and the transmitter.
Step 2. Plug one end of the provided power adapter into the back of the
WAVECOM
outlet. Turn the ON/OFF switch to ON position and indicator light should
go on.
Step 3. If your satellite receiver or laser disc player has only one set of A/V output
jacks, and you had to disconnect your TV from those jacks to connect
WAVECOM
single VHF/UHF OUT port on the satellite receiver or laser disc player to
the VHF/UHF IN port on your TV.
Step 4. Locate and orient the transmitter according to the chapter of this manual
titled "Orienting Units for Optimal Performance
TM
8 WAVECOM
TM
Sr. transmitter and the other end into any 120-volt wall
TM
Sr., reconnect the TV by connecting coaxial cable from the
Sr. owner's manual
TM
Sr. ON/OFF switch is in the OFF position.
."