RF-Link WAVECOM Sr Owner's Manual page 27

Using the Remote Control Feature
WAVECOMTM Sr. not only allows you to send crisp audio/video from one area
to another, it also gives you the ability to control the source using your existing
remote control device. The infrared (IR) signal at the WAVECOMTM Sr. receiver
and then sends it back to the WAVECOMTM Sr. receiver and then sends it back
to the WAVECOMTM Sr. transmitter, where the RF signal is converted back to
the original IR signal and used to control the audio/video source (see below)
H o w t o u s e t h e I R E x t e n d e r M o u s e
The IR extender mouse connects to the WAVECOMTM Sr. transmitter through
its own special connector plug. The extender mouse emits high intensity IR signal,
bathing your components with the remote signal. To use the IR extender mouse,
follow the instructions below.
1. Plug the IR extender mouse into the jack located on the backside of the
WAVECOMTM Sr. transmitter housing. The jack for the IR extender
mouse is located to the left side of the left audio jack (white)
2. Located the IR sensor on the source component you wish to control. If the
sensor is not clearly labeled on the front of the component, either consult
the your remote control at different areas on the front of the component
from less than 1 inch away. When it works, you have found the
approximate location of the IR sensor.
3. Orient the IR extender mouse housing so that it points in the general
direction of the IR sensors of the source components you wish to control.
4. Position the WAVECOMTM Sr. receiver so that your remote control
signal remote control, point it at the front of the receiver.
TM
WAVECOM Sr. owner's manual 25