How To Transmit Audio From Your Cd Player Or Cassette Deck - RF-Link WAVECOM Sr Owner's Manual

How to transmit audio from your CD player or
cassette deck
Your can transmit audio either directly from your CD player or cassette deck, or you
can connect them to your stereo receiver. For either scenario, to enjoy audio on
remote speakers, you must connect either powered speakers or an amplifier to the
TM
WAVECOM Sr. receiver at the remote site (see "Connecting the Receiver").
Step 1. Make sure the WAVECOM
Connect one set of audio/video (A/V) cables to the two audio jacks (red and
white) of the transmitter and to the LINE OUT jacks of the CD player or
cassette player. Be sure the red and white plugs match the red and white
jacks on both the transmitter and the CD/cassette player. The yellow
video plug is not used.
Step 2. Plug one end of the provided power adapter into the back of the
WAVECOM
outlet. Turn the ON/OFF switch to ON position and indicator light should
go on.
Step 3. Locate and orient the transmitter according to the chapter of this manual
titled "Orienting Units for Optimal Performance."
TM
14 WAVECOM
TM
Sr. transmitter and the other end into any 120-volt wall
Sr. owner's manual
TM
Sr. ON/OFF switch is in the OFF position.