How To Receive Audio On Any Remote Speakers - RF-Link WAVECOM Sr Owner's Manual

How to receive audio on any remote speakers

You can enjoy wireless sound without using powered speakers as long as you use an
amplifier or stereo receiver to boost the signal from the WAVECOM
This feature allows you to listen to a multiple-CD changer or other audio source on a
stereo in another room.
Step 1. Make sure the WAVECOM
Connect one set of A/V cables to the two audio jacks (red and white only)
of the receiver and to the IN 1 or IN 2 jacks on your stereo receiver or
amplifier. Be sure the red and white plugs match the red and white jacks
on the WAVECOM
The yellow video plug is not used.
Step 2. Run speaker wire from your stereo receiver or amplifier to your speakers as
you normally would.
Step 3. Plug one end of the provided power adapter into the back of the
WAVECOM
Turn the ON/OFF switch to ON position and indicator light should go on.
Step 4. Locate and orient the WAVECOM
of this manual titled "Orienting units for optimal performance."
TM
20 WAVECOM
TM
Sr. receiver and the stereo receiver or amplifier.
TM
Sr. receiver and the other end into any 120-volt wall outlet.
Sr. owner's manual
TM
Sr. ON/OFF switch is in the OFF position.
TM
Sr. receiver according to the chapter
TM
Sr. receiver.