Make sure there are no flammable materials close to the machine while operating. Only use Antari fluid. Other fluid may lead to heater clog and malfunction. If the machine fails to work, unplug the machine and stop operation immediately.
5 meters for the output direction of the machine. Step 2: Fill the fluid tank with Antari FLC fog fluid. Step 3: Connect the machine to suitable rated power supply. To determine the power...
requirement for the machine refer to the label on the back of the machine. Always connect the machine to a protected circuit and ensure it is properly grounded to avoid risk of electrocution. Step 4: Turn on the machine by connecting the power cord and turning the Neutrik Powercon.
Page 6
To active Volume Mode To emit fog under 2-Second Jet Mode [Stop] To stop output or go back to main screen Functions Value Description Interval Set 10-300 Seconds Interval time under Timer Mode Duration Set 2-15 Seconds Duration time under Timer Mode Timer Output 50-100% Output volume under Timer Mode...
Page 7
set first: Output Volume Setup - Press [Menu] button until LCD screen displays “Volume Output” and then press ▲ or ▼ button to set the output percentage from 50-100%. After finishing the above setting, go back to main screen by pressing [Stop] button. To activate Volume Mode, press [Volume] button under main screen.
Page 8
DMX Channel Function Channel DMX Value Range Function 0 – 5 Fog Off Fog Output 50 – 100% 6 – 255 Fog Output 100% for 2 seconds (under 2-Second Jet Mode) DMX Connector Pin Assignment The machine provide 3 or 5 pin XLR connector for DMX connection. Diagram below indicate pin assignment information Function Ground...
Page 9
With the transmitter it is possible to emit fog via radio signal at maximum distance of 50 meters. Press the button “A” or “B”, to emit fog. *Receiver The receiver is tested and pre-attached to the rear of the machine. The included transmitter has been registered to the machine before shipping.
Liquid Only use Antari FLC water-based liquid for the W-715 Fogger. The machine is tested and calibrated with this liquid to get the best output performance. Warranty will be void if any other type of liquid is used, improper use of liquid may lead to machine failure and malfunction.
Page 11
5 M Fluid tank capacity 2.4 L (0.63 gal) Fluid consumption 300 ml/min Compatible fluid Antari FLC water-based fluid Control option LCD control panel, wireless remote control, DMX 512 DMX channels 1 channel, Output volume Power connection Neutrik Powercon...
Need help?
Do you have a question about the W-715 and is the answer not in the manual?
Questions and answers