Print Options - 3D Printing Systems UP MINI User Manual

Status bar: The bottom status bar shows the current layer that is currently being printed The bottom status bar shows the current layer that is currently being printed The bottom status bar shows the current layer that is currently being printed
•
and the remaining time to complete the job. and the remaining time to complete the job.
Intilise Switch: The switch on the front of the printer can also be used to abort the current The switch on the front of the printer can also be used to abort the current The switch on the front of the printer can also be used to abort the current
•
print job, print the platform do print job, print the platform down and then put the printer into sleep mode.
Lights On/Off: By pressing the Intilise Switch twice, will toggle the internal lighting on By pressing the Intilise Switch twice, will toggle the internal lighting on By pressing the Intilise Switch twice, will toggle the internal lighting on
•
or off.

Print Options:

Speed: Fine, Normal or Fast. This simply determines the speed at which the printer moves. As a
general rule, the slower you print, the better the quality of the parts. For tall parts, running at Fast general rule, the slower you print, the better the quality of the parts. For tall parts, running at Fast general rule, the slower you print, the better the quality of the parts. For tall parts, running at Fast
speed can be problematic as the printer can vibrate to the extent that print quality is affected. For speed can be problematic as the printer can vibrate to the extent that print quality is affected. For speed can be problematic as the printer can vibrate to the extent that print quality is affected. For
large surface area parts, the Fine setting can be problematic as the printer takes longer to print the large surface area parts, the Fine setting can be
part and the corners are therefore more likely to lift a little bit. part and the corners are therefore more likely to lift a little bit.
UnSolid Model: This function is useful for printing ST This function is useful for printing STL files that are not perfect. A perfect STL
file is a fully enclosed surface (water tight), with no holes in the surface skin, and no overlapping file is a fully enclosed surface
surfaces. If your file is not perfect, this option should allow you to print it anyway. If your file is not perfect, this option should allow you to print it anyway. If your file is not perfect, this option should allow you to print it anyway.
TIP: Once the print has started, you can unplug the PC from the printer. The print job is stored in Once the print has started, you can unplug the PC from the printer. The print job is stored in Once the print has started, you can unplug the PC from the printer. The print job is stored in
the printer's internal memory, so the the printer's internal memory, so the computer is no longer required.
UP Mini 3D Printer User Manual 3D Printer User Manual
wn and then put the printer into sleep mode.
. This simply determines the speed at which the printer moves. As a . This simply determines the speed at which the printer moves. As a
problematic as the printer takes longer to print the
, with no holes in the surface skin, and no overlapping
files that are not perfect. A perfect STL
38