3D Printing Systems UP MINI User Manual page 43

After the calibration model is printed, measure the X1 and X2 length, as shown in the pictures After the calibration model is printed, measure the X1 and X2 length
below.
Open the "Calibrate" box form the "3D Print" menu. Open the "Calibrate" box form the "3D Print" menu
Then enter the measured X1 and X2 values into the appropriate boxes. enter the measured X1 and X2 values into the appropriate boxes.
IMPORTANT NOTE: Before you enter any new calibration values, always click the "Reset" Before you enter any new calibration values, always click the "Reset" Before you enter any new calibration values, always click the "Reset"
button, otherwise the new values get added to the old ones. Before you enter any new values, the button, otherwise the new values get added to the old ones. Before you enter any new values, the button, otherwise the new values get added to the old ones. Before you enter any new values, the
bar at the very top of the screen should read: XY: 0.00 deg / XZ: 0.00 deg. bar at the very top of the screen should read: XY: 0.00 deg / XZ: 0.00 deg.
Next, take down the Front Centre 'L' shaped component
value into the Z box. If it deviates to the right side, the value to be put into the Z box will be a po value into the Z box. If it deviates to the right side, the value
itive value. If the deviates to the left, the value to put into the Z box will be a negative value. itive value. If the deviates to the left, the value
Finally, measure the height of Front Center component, which should be 40mm if it is not scaled. Finally, measure the height of Front
Enter the exact measured value into Enter the exact measured value into the "H" box of the "Calibrate dialogue box.
Click "OK" to record all these values and exit the calibration window. Click "OK" to record all these values and exit the calibrat
After a lot of printing, the nozzle may be covered with a layer of oxidized ABS on the outside of the After a lot of printing, the nozzle may be covered with a layer of oxidized ABS
nozzle. When the printer is printing, this oxidized ABS may melt on the nozzle, and may create di . When the printer is printing, this oxidized ABS may melt on the nozzle, and may create dis- . When the printer is printing, this oxidized ABS may melt on the nozzle, and may create di
colored spots the model. To avoid this you need to regularly clean the nozzle. colored spots the model. To avoid this you need to regularly clean the nozzle.
UP Mini 3D Printer User Manual 3D Printer User Manual
Centre 'L' shaped component, and measure its deviation. Put the exact
put into the Z box will be a negative value.
, as shown in the pictures
, and measure its deviation. Put the exact
he Z box will be a pos-
be 40mm if it is not scaled.
on the outside of the
44