3D Printing Systems UP MINI User Manual page 15

21. Scale the bunny by 50%, click "Scale" and select "0.5". Scale the bunny by 50%, click "Scale" and select "0.5".
22. Click "Place" this will centre the model this will centre the model or models on
the base of the print area print area on the software.
23. Click the "Print" icon Click the "Print" icon and click "Preferences"
24. Select the following: the following:
Z Resolution: "0.2mm" "0.2mm"
Fill: Hollow Honeycomb (bottom right) Hollow Honeycomb (bottom right)
Support Angle: 30 degrees 30 degrees
Typically these are the only values you'll need to these are the only values you'll need to
change.
Click "OK"
25. Select the overall print quality Select the overall print quality
Normal = Average quality = Average quality
Fine = Good quality and takes longer = Good quality and takes longer
Fast = Draft quality and takes less time = Draft quality and takes less time
Now click "OK" to start your first print! Now click "OK" to start your first print!
26. The software will now spool the print job to printer. The software will now spool the print job to printer.
Once finished spooling, the printer will beep , you can Once finished spooling, the printer will
then disconnect the USB cable from your computer if then disconnect the USB cable from your computer if
you wish.
27. The printer will now start to preheat the platform and The printer will now start to preheat the platform and
the extruder. You can watch the temperature raise by the extruder. You can watch the temperature raise by
clicking "3D Print" and "Maintenance" clicking "3D Print" and "Maintenance"
UP Mini 3D Printer User Manual 3D Printer User Manual
Chapter 3.2.4 Model Chapter 3.2.4 Model
Transformations
Chapter 3.3.6 Print Preferences Chapter 3.3.6 Print Preferences
Chapter 4. Printing Chapter
16