Table of Contents
Advertisement
5. Load the spool of filament
of filament onto the back of the printer.
Check the diagram for the correct orientation of the
Check the diagram for the correct orientation
spool..
6. Feed the end of the filament
Feed the end of the filament through the filament guide.
Feed the filament through the feeder
about 10cm out the other end of the tube.
about 10cm out the other end of the tube.
7. Place the Filament and tube inside the back of the top
ilament and tube inside the back of the top
door.
8. Push the end of the filament into the print head feed
Push the end of the filament into the print head feed
hole.
9. Slide the Perfboard into the platform
Slide the Perfboard into the platform slots (between the
groves) and attach the binder clips on the front in order
groves) and attach the binder clips
to hold the Perfboard in place. Always remove the
to hold the Perfboard
Perfboard after printing
after printing to remove printed models from
the printer.
UP Mini 3D Printer User Manual
3D Printer User Manual
through the feeder tube and feed
14
Advertisement
Table of Contents
Need help?
Do you have a question about the UP MINI and is the answer not in the manual?