Advertisement
TOOLS AND SUPPLIES REQUIRED
Flat-tip screwdriver
Phillips screwdriver
Shop towel
Diagonal cutters
10 mm Combination wrenches
Isopropyl alcohol
Utility knife
INSTALLATION
Customer Information: The information in this
installation instruction is intended for use only by
skilled technicians who have the proper tools,
equipment, and training to correctly and safely add
equipment to your vehicle. These procedures
should not be attempted by "do-it-yourselfers."
1.
Make sure you have the anti-theft code for the
radio, then write down the frequencies for the
preset buttons.
2.
Disconnect the negative cable from the battery.
3.
Remove the audio unit.
Without Navigation Unit:
•
Using a flat-tip screwdriver wrapped with a
shop towel, gently pry out on the audio panel
to remove the five clips. Unplug the connectors
and remove the audio panel.
VEHICLE
CONNECTOR
AUDIO PANEL
2 of 8
•
Remove the four screws that fasten the audio
brackets. Pull the audio unit out toward you,
unplug the vehicle connector and antenna lead
from the rear of the audio unit.
AUDIO
BRACKET
With Navigation Unit:
•
Remove the driver's and passenger's center
console trim pieces (three clips each). Take
care not to damage the clips.
DRIVER'S CENTER
CONSOLE TRIM
CLIPS (5)
All 23607 (0205)
VEHICLE
CONNECTOR
AUDIO
UNIT
SCREWS
(Reuse.)
CLIPS (3)
©
2002 American Honda Motor Co., Inc - All Rights Reserved.
ANTENNA
LEAD
AUDIO
BRACKET
PASSENGER'S
CENTER
CONSOLE TRIM
Advertisement
