Routing the BUS cable
6.
Route the BUS cable.
Without Navigation Unit:
•
Route the BUS cable from the dashboard
opening to the driver's floor. Pull out the end of
BUS cable 30 mm from the end of the vehicle
20-pin connector, and secure the BUS cable to
the vehicle harness and frame with three wire
ties.
WIRE TIE
VEHICLE
HARNESS
30 mm
FRAME
BUS
CABLE
4 of 8
VEHICLE
BUS CALBE
20-PIN
14-PIN
CONNECTOR
CONNECTOR
WIRE
TIE
With Navigation Unit:
•
Route the BUS cable from the dashboard
opening to the driver's floor. Pull out the end of
BUS cable 30 mm from the end of the vehicle
20-pin connector, and secure the BUS cable to
the vehicle harness with wire ties.
•
Cut the EPT seal in half. Attach 1/2 of the EPT
seal on the edge of vehicle body to protect the
BUS cable. Before attaching the tape, wipe the
surface with isopropyl alcohol.
•
Secure the BUS cable on the vehicle frame
with two wire ties.
WIRE TIE
BUS
CABLE
VEHICLE
HARNESS 20-PIN
CONNECTOR
WIRE
TIE
FRAME
All 23607 (0205)
EPT SEAL
FRAME
Clean with isopropyl
alcohol.
BUS CABLE
14-PIN
CONNECTOR
30 mm
©
2002 American Honda Motor Co., Inc - All Rights Reserved.
CENTER
PANEL
OPENING