Datavideo HS-2000 Hand Carried Studio Instruction Manual page 10

T-Bar
The T-Bar is used to carry out a manual transition such as a wipe, fade,
mix or key. When it has travelled as far as it can go the transition is
complete.
How to calibrate the T-bar:
1. Turn off the HS-2000 power, and push the T-Bar up as far as it can go to
its Top or AIR position then move the T-Bar back down by 2mm.
2. Press and hold in the SET and SUB SOURCE 1 buttons at the same time.
3. Have a colleague turn on the HS-2000 power. When the SET button and
SUB SOURCE 1 buttons are illuminated yellow release both buttons.
4. Push down the T-Bar as far as it can go to its bottom or PVW position and
then move the T-Bar back up by 2mm. Now press the CUT button.
5. Again push the T-Bar up as far as it can go to its Top or AIR position. Now
press the TAKE button.
6. Press SET button again to end the calibration process.
WARNING: If you do not follow the T-Bar calibrating steps correctly the
T-Bar may work incorrectly
Main Source
Used to select which of the source input channels or backgrounds that are
sent to the Main video PROGRAM output.
Sub Source
Used to select which of the source input channels or backgrounds will be
transitioned to or used as a sub source in an effect such as PIP.
Audio mixer
These CH1~CH4 Audio Level Faders are for controlling the CH1~CH4 audio
mix.
These faders correspond to the Audio Source selector buttons and control
the relative volume of each input in the master output as well as the master
output level. They are called faders because they are used to decrease
(rather than increase) the signal levels to create a balanced and pleasing
mix. When the CH1~CH4 Audio Level Faders are set at -6dB, or Unity, they
pass the audio signal through at the same level as when it entered the bus.
This is why the level setting at the Input Bus is so important.
MASTER
This Slider is for controlling the audio level for the Mixed audio output.
Headphone
Accepts a stereo mini jack plug for stereo headphones. Used with the Audio
Monitor Button. The headphone volume is adjusted by the rotating Head
phone volume control.
Headphone Volume Control
Controls Headphone volume level.
Use the Headphone section to monitor any of the sources ( CH1, CH2,
CH3, CH4 or "Master" ) output.
10