Overview; Shipping Information; Connecting Ac Power; Power Specifications - Dialogic IMG 1004 Quick Start Manual

Overview

This IMG 1004 Quick Start Guide is an abbreviated guide which explains how to connect
power and network cabling. For more information on installation and setup, please reference
the online documentation at http://www.dialogic.com/manuals.
Note: To access the Dialogic Technical Support website, a support contract with Dialogic
must be obtained. Once the support contract is obtained, a username and password will be
supplied via email. Use the credentials supplied to log on to the Dialogic Technical Support
Website to access software upgrades etc.

Shipping Information

Review the packing list to check that all the items listed on the packing list have been sent.
Should any discrepancies exist, contact your Dialogic Representative immediately.

Connecting AC Power

Power Specifications

The IMG 1004 is powered by an AC voltage. The AC input power must conform to the
specifications in the table below. Insert one end of AC cord into rear of IMG 1004 and the
other end into a grounded wall outlet, uninterruptible power supply (UPS), or surge
protector.
AC
Power 120 – 240 VAC / .65 - .25 Amps
Frequency 50 or 60 Hz

AC Power Module

Located on the rear of the IMG 1004 is an AC input power module with an integrated fuse,
power switch, and standard three position female AC input connector. This connector allows
the docking station to interface with all variations of AC outlets by simply using a standard
power cable and compatible outlet plug. See IMG 1004-Installation and Setup Guide > IMG
1004-Hardware Installation in online documentation.
Operating Range
90 – 240 VAC
50-60 Hz
Index
5