Set Up A Password - Alcatel OmniAccess 512 Getting Started Manual

o Configuration Modes o
You can configure your OmniAccess
512 through the User Interface (
enter the UI, type
( ) and press
->
( ) will be displayed, indicating that
=>
you are in mode. From here, you
UI
can type and press
the Main Menu.
For more information on using the
refer to the
OmniAccess 512 User
.
Manual
To return to
CLI
type either or
( ) and press
=>

4. Set up a Password

Before you begin configuring your switch, you should
change the password for the
login account provides full access to all switch
management functions.
The factory default password for the
. Use the following procedure to change the
password for the
). To
UI
at the prompt
CLI
. The prompt
UI
to view
,
UI
mode from mode,
UI
at the prompt
UI
.
login account. The
account is
account:
a. Type
at the
new_password
. For example, to change the factory
default password (
( ), enter the following:
->
b. No confirmation message will appear onscreen.
Only the system prompt (
o Important Note o
To create an all-numeric password (for
example,
quotation marks before and after the
password
All new passwords take effect at your next login
session.
If the switch will be managed via
, refer to your switch's user
SNMP
manual for instructions on setting
passwords.
SNMP
old_password
prompt and press
CLI
) to a new password
) will appear.
->
), you must enter
.
o Note o
Setting Up Software 7