If The Half-Cuts Are Not Deep Enough; If The Display Remains Blank When Power Is On; If The Input Display Does Not Appear - Brady BMP 91 User Manual

F. If the half-cuts are not deep enough...
If the cutter does not half-cut the tube or label properly, you can
do the following:
1.
Change the cut depth.
Enter [Menu] > Setting > Cutter > Half Cut > "Depth".
2.
Select a cut depth setting that is lower than the current. (The
lower the setting, the deeper the cut depth.)
Cut Depth
1
2
3
4
5
6
7
8
3.
If the current cut depth is already lowest at level "1", this
means that the cutter is worn out. Replace the cutter with a
new blade.
For detailed instructions on how to replace the cutter, please
refer to the "E. To replace the cutter" section in the chapter,
"6. Maintaining Your Printer".
4.
If the cutter still does not cut properly with a new blade at the
lowest cut depth, contact Brady Technical Support.
Deeper
Less Deep
For detailed instructions on how to replace the cutter,
refer to the "To replace a cutter" section in "6.
Maintaining Your Printer".
G. If the display remains blank when power is on...
1.
Turn off the printer and make sure that the AC adapter is
securely plugged into the power outlet and is connected to the
main unit. Then turn the power back on.
Alternatively, check if you are using an AC adapter that is
made for use with the printer. Using another AC adapter
could result in circuit damage or overheating.
H. If the input display does not appear...
This can happen when bad input data has been received.
Restore the printer to initial (factory) settings:
1
Enter [Menu] > Settings > Factory Settings.
Menu
A message appears, asking for confirmation.
2.
Press [OK].
OK
3.
If the input display still does not appear, contact Brady
Technical Support.
7. Troubleshooting
89