Powering The Printer With An Ac Supply - Brady BMP 91 User Manual

2.
Grasping the finger tabs of cartridge, insert the ribbon
cartridge with its label facing up, as shown in the diagram
below.
a
3.
Ensure that the printer ribbon is right over the printhead and
push the cartridge slightly to snap into place.
4.
Close the cover firmly so that you can hear and feel that it
latches.
To clear the printhead area of used ribbon, turn the top
spool of the ribbon counterclockwise.
English
18 2. Setting Up Your Printer
b
C. Powering the printer with an AC Supply
USE ONLY: a) 100-240V AC power supply, b) the AC
adapter supplied in your package.
KEEP: a) the AC plug clean, b) the area around the AC
adapter clear of any clutter.
1.
Firmly insert the thin
round end of the
adapter cable into the
plug-in port on the
back of the printer.
2.
Firmly plug the other end of the cord into an
electrical outlet. (Your outlet may look
different from what is shown here.)
3.
Press the [Power] key.
The printer starts up. The Brady logo appears and the last tag
editing job gets loaded on the LCD screen.
To turn off the printer, press the
the [OK] key.
OK
[Power] key and then