Standard Features; Figure 1-2. Digicast Media Router S2 Receiver - Rear Panel - Comtech EF Data CMR-5975 Installation And Operation Manual

Digicast Media Router S2 Receiver CMR-5975 (MR-S2)
Introduction
Figure 1-2. Digicast Media Router S2 Receiver – Rear Panel
1.2

Standard Features

Based on an embedded architecture, utilizing a FreeScale MPC859 CPU and eCOS Operating
System, the MR-S2 provides the following features:
•
High Reliability
•
DVB-S and DVB-S2 L-Band Input
•
Ethernet Output rates as high as 83 Mbps (1,500 byte packets)
•
Support for Multicast and Unicast IP datagrams
•
Supports the decapsulation of MPE
•
MPE Section Packing and Non-Section Packing on a PID-by-PID basis
•
Supports encapsulation of transport streams over IP
•
Support for all valid PIDs in 8192 range
•
64 PIDs
•
MPEG-2 188/204-byte operation
•
Support for 802.1Q VLAN Tags
•
IGMP for Multicast Route Announcements
•
Redundancy
•
Configurable Telnet and HTTP ports for security
•
Color LEDs for status monitoring and rapid fault isolation
•
Management (monitor, control and configuration):
Web Interface
TFTP for field software/firmware upgrade
Terminal Interface
Telnet
SNMP V2 (Private and MIB II) Support
Vload
1–2
Revision 3
MN-CMR5975-IOM