ATCOM IP2G4A User Manual page 32

Ippbx
Hide thumbs Also See for IP2G4A:
Table of Contents

Advertisement

IPPBX IP2G4A User Manual
Caller ID
Define the Caller ID number to be matched on incoming calls. Leave this field blank to match any or no CID info.
Special characters described in chapter 4.3 can be used here as same.
DID number
Define the expected DID number if your trunk passes DID on incoming calls. Leave this blank to match calls with
any no DID info. The DID for SIP trunk is usually as same as the account (others can only dial the account
number to dial into PBX), then just leave it blank is OK .
Extension
Define the extension for DID number. This field is usually unavailable for most VoIP trunk, if you VoIP provider
support DID, you can set it. You can only input number and '-' in this field, and the format can be XXX or
XXX-XXX. The count of the number must be only one or equal the count of the DID number. Up to 100 DID
numbers can be set.
For example: Set DID number: 6000-6010,Extension: 6000,All inbound calls to 6000-6010 will be forwarded to
extension 6000. Set DID number: 6000-6010, Extension: 6000-6010, inbound calls to 6000-6010 will be
forwarded to corresponding extension.
2) Inbound Trunk Selection
Select the trunks for which this inbound route apply.
3) Time
Select appropriate time intervals for when this inbound route apply.
4) Path
Set the destination for incoming calls. If Extension is set, this option will not take effect.
5) Fax Detection
Configure if detecting faxes in this inbound route.
NOTE: Please choose IVR as the destination above before configure fax detection (recommended)
Destination
Configure where the faxes will be routed when faxes are detected.
No detect
Do not detect faxs
Faxs
Send faxes to an extension. If choosing a FXS extension here, the fax will be sent to the FXS port selected, you
should connect a fax machine to this FXS port. If Choosing a VoIP extension, the fax will be sent to the
extension's voicemail as an attachment.
NOTE: If you receive faxes with custom Email address, the "SMTP settings" should be configured successfully in
advance. If you receive faxes with E-mail address configured in VOIP extension voicemail, you should first make
sure the tested email to your email address works fine.
~ 31 ~
ATCOM TECHNOLOGY CO., LIMITED

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents