Debug Mac-Manager - Cisco Catalyst 3550 Command Reference Manual

Appendix B Catalyst 3550 Switch Debug Commands

debug mac-manager

Use the debug mac-manager privileged EXEC command to enable debugging of the platform-specific
MAC address table manager software module. This command debugs the platform-specific part of
learning MAC addresses on VLANs and updating the hardware with the necessary information. Use the
no form of this command to disable debugging.
Syntax Description This command has no arguments or keywords.
Defaults
Debugging is disabled.
Command Modes
Privileged EXEC
Command History Release
12.1(4)EA1
Usage Guidelines
The undebug mac-manager command is the same as the no debug mac-manager command.
Related Commands Command
show debugging
OL-8566-02
debug mac-manager
no debug mac-manager
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled. For
syntax information, select Cisco IOS Release 12.2 Configuration Guides
and Command References > Cisco IOS Configuration Fundamentals
Configuration Guide, Release 12.2 > System Management >
Troubleshooting and Fault Management.
Catalyst 3550 Multilayer Switch Command Reference
debug mac-manager
B-25