Frequently Asked Questions (Faqs) - Marmitek Powermid XL User Manual

8 Frequently asked questions (FAQs)

Does the signal of the Powermid XL travel through walls and ceilings?
Yes. The Powermid XL uses RF signals with a transmission frequency of 433 MHz.
These signals go through walls and ceilings.
Can I also use the Powermid XL to control equipment in a locked cupboard?
Yes. You will find an extra connection (3.5 mm plug) on the back of the Powermid XL
receiver. This can be used to connect an IR Eye, which you can use to control
equipment in a locked cupboard.
How do I check whether the Powermid XL transmits the signal of my remote
control?
When transmitting the signal of your remote control, a red LED will light up on both the
transmitter and the receiver.
Can I transmit signals from my wireless keyboard using the Powermid XL?
If your wireless keyboard uses standard infrared signals (40 kHz), you can extend this
wireless signal. Contact the supplier of the wireless keyboard to check whether your
keyboard uses this frequency.
Does the Powermid XL also work with Bang & Olufsen equipment?
No. Bang & Olufsen uses a different infrared frequency. The Powermid XL does not
support this frequency.
Is it possible to use several IR transmitters with each other?
Yes, however, the IR transmitters will all transmit the same IR signal, which is received
by the IR receiver.
Do you have any other questions that have not been resolved by the above
information? Please go to www.marmitek.com
6 © MARMITEK