6. USAGE
1.
Switch on the HDMI source (e.g. TV Decoder or Media Centre PC).
2.
Switch on the display device (for instance HDTV or projector) and
select the appropriate input. Usually you will do this by pressing the A/V
or EXT button of your remote control.
3.
You will receive images from the connected A/V device immediately.
4.
The MegaView 81 can also be used to operate the HDMI source from
another room, by pointing your own remote control at the IR receiver
and pressing a button.
7. FREQUENTLY ASKED QUESTIONS
Bad (or no) image and sound
x
Check if the A/V device is switched on.
x
Use only CAT5e/CAT6 cable as specified in chapter 3 (CAT5e Cable
Requirements).
x
Check if the CAT5e/CAT6 cable provides a solid connection (no cable
faults).
x
Check if the RJ-45 has been connected according to the EIA/TIA
T568B standard.
x
Please ensure that the maximum cable length is not exceeded.
x
Install your system as far away from any RF sources (wireless devices)
as possible.
x
Set a low resolution on your HDMI source. The CAT5e/6 cable used
probably cannot deal with the higher resolution bandwidth.
Do you have any questions that are not answered above?
Please check www.marmitek.com.
6
© MARMITEK