Status Of The Lights; Frequently Asked Questions (Faqs) - Marmitek MegaView 76 User Manual

5.2 Status of the lights

1. SIGNAL light
• Lights up continuously: HDMI signal is present.
• Flashing: no HDMI signal present yet.
• OFF: HD transmitter/HD receiver is OFF.
2. USB light
• Flashing fast: a USB connection has been established.
• Flashing slow: no USB connection has yet been established.
• OFF: transmitter/receiver is OFF
If working properly, the ''SIGNAL'' light will continuously light up and the ''USB'' light will
flash quickly.

6 Frequently asked questions (FAQs)

No (or poor) image and sound
If you experience poor or no picture after connecting the MegaView 76™, try detecting
the problem by connecting the devices to your TV or projector one at a time. This
enables you to determine whether the problem is in the HDMI sources, the HDMI
cables, the MegaView 76™ or the TV.
• Make sure the power adapter is connected and plugged in.
• For the best picture and sound quality, only use High Speed HDMI® certified
cables.
• Do not use HDMI cables longer than those specified in the technical data.
• Check the HDMI cables and/or connectors for damage.
• Both the HDMI source and your TV or projector should fully support HDMI.
No (or poor) image and sound
• Ensure that the HDMI source is switched on.
• Only use CAT5e/6 cables, as specified in section 4.
• Ensure that the CAT5e/6 cable is connected well (no breakages).
• Make sure the RJ-45 is connected according to the EIA/TIA T568B standard.
• Make sure that the maximum cable length is not exceeded.
• Prevent installing your system close to RF sources (wireless devices) as much as
possible.
• Set your HDMI source to a lower resolution, the CAT5e/6 cable used may not be
able to handle the bandwidth of higher resolutions.
Do you have any questions that are not answered here?
Please check www.marmitek.com
MegaView 76™ 7