Table of Contents
Advertisement
ArbStudio
The following fields are available on the Clock Generator tab:
• Enable ‐ Turns the Clock Generator Module on or off.
• Frequency ‐ Sets the frequency (MHz) of the Clock Generator. The output frequency depends on the
Sample Rate set by the user on the Setup Device Timing tab.
Note: User entries can be recalculated to allow frequency values.
• Duty Cycle ‐ Sets the generated clock duty cycle of the clock signal.
Note: User entries can be recalculated to allow duty cycle values.
• Delay ‐ It sets the delay to the synchronized signal.
Note: User entries can be recalculated to allow delay values.
• Strobe Operation ‐ Lets you logically combine the Output clock with the Extended Trigger In vector.
Possible options are: NOP, OR, AND, XOR, NOT, NOR, NAND, XNOR, FORCE LOW, and FORCE HIGH.
Pattern Settings - The Trigger In Tab
Set Trigger In parameters using the Trigger In tab.
S
C
OURCE
ONNECTOR
Select the physical source for a Trigger In event. The possible options include:
• BNC Trigger IN ‐ The trigger event is received by the dedicated BNC Connector on the instrument front
panel.
86
918221 RevA
Advertisement
Table of Contents
