Multi Device Deskew Delay (1104 with Expansion Bus option only)
This parameter can set a fine delay between multiple devices in order to compensate the skew between the
outputs belonging to different devices.
The skew delay is only active on Slave devices and can add a positive delay respect to the Master.
When deskewing the channel delay of a slave device with respect to the master, the Multi Device Deskew delay
must be used in conjunction with the trigger delay. Multi Device Deskew delay sets a fine delay and can only be
positive, while the trigger delay sets a normal delay and can also be slightly negative.
The deskew delay is only effective when all devices work with the same sampling frequency that must be in the
following list: 250 MHz, 200 MHz, 150 MHz, 100 MHz, 75 MHz, 50 MHz, 37.5 MHz, 25 MHz.
The Channel Out Math Tab
You can set a communication between adjacent channels allowing computations to be performed between
generated waveforms or between a waveform and a constant.
• Use the radio button to Enable operation on a channel pair.
• Select the channel where the operation result is to be performed. The selected channel is the Receiver
(RX) and the other one is the Transmitter (TX).
918221 RevA
Getting Started Manual
43