ArbStudio
Safety Requirements
This section contains information and warnings that must be observed to keep the instrument operating in a
correct and safe condition. You are required to follow generally accepted safety procedures in addition to the
safety precautions specified in this section.
Safety Symbols
Where the following symbols appear on the instrument's front or rear panels, or in this manual, they alert you
to important safety considerations.
This symbol is used where caution is required. Refer to the accompanying information or documents in order to
protect against personal injury or damage to the instrument.
This symbol warns of a potential risk of shock hazard.
This symbol is used to denote the measurement ground connection.
This symbol is used to denote a frame or chassis connection.
This symbol is used to denote a safety ground connection.
On (Supply). This is the DC power connect/disconnect switch at the back of the instrument.
Off (Supply). This is the DC power connect/disconnect switch at the back of the instrument.
This symbol is used to denote Power. It is located on the front panel and denotes Power On/Off status of the
instrument.
8
918221 RevA