Other buttons on the Setup System screen include:
• Reinitialize to Default ‐ Click this button and all devices are set as the slave.
• Set Slave Start on Master Start ‐ Sets all slave devices to Start On the Master Channel Start Event.
• Set Slave Stop on Master Start ‐ Sets all slave devices to Stop On the Master Channel Stop Event.
Setup Device
Overview
Use the Setup Device tabs to quickly access the following ArbStudio parameters (the Timing tab is shown by
default):
• The Timing Tab (on page 42)
• The Channel Out Math Tab (on page 43)
• The Trigger OUT Math Tab (on page 45)
• The Digital I/O Tab (on page 45)
• The Strobe Tab (on page 46)
918221 RevA
Getting Started Manual
41