LeCroy ArbStudio Manual page 106

ArbStudio
Instruction
Reset Trigger
Reset the trigger event value
Event
PLEASE NOTE THE FOLLOWING:
• The last sequencer instruction must be RETURN.
• REPEAT WAVEFORM: the generated vectors are asynchronous respect to the clock generator signal.
• SYNC REPEAT WAVEFORM: the generated vectors are synchronous respect to the clock generator signal.
Sync signal can be delayed with Sync Delay.
• Sequencer Memory depth is 1024 instructions.
• Waveforms Memory depth is 1048576.
• A block of instructions can be repeated with Loop Begin / Loop End parameters. Loop Begin marks the
first instruction of the loop, Loop End marks the last instruction.
LOOP REPETITIONS parameter is the number of times that the loop will be repeated. Allowed values are
from 1 to 8191.
Add an operation to the sequencer by selecting the operation in the Operation List tab, and then pressing the
Add button.
The Wait event parameters window is shown where you can manage or change the parameters for the selected
instruction.
106
Explanation
Loop Mode: NO LOOP, LOOP BEGIN (it marks the first instruction
Loop Mode: NO LOOP, LOOP BEGIN (it marks the first instruction
of a loop), LOOP END (it marks the last instruction of a loop).
of a loop), LOOP END (it marks the last instruction of a loop).
Parameters
918221 RevA