Table of Contents
Advertisement
ArbStudio
The Settings screen is divided into the following tabs:
1. The General Tab (below)
2. The Run Mode Tab (Waveform Sequence) (on page 34)
3. The Run Mode Tab (Modulation) (on page 36)
4. The Trigger IN Tab (on page 38)
5. The Trigger OUT Tab (on page 39)
Channel Settings - The General Tab
The General tab is shown by default when the Channel Settings screen is opened.
Sections of the Channel Settings General tab are explained as follows:
Output Impedance
It allows setting the channel output impedance and it can be set at: 50 Ohm, Low or High Impedance.
Trigger Delay
You can set a delay from the trigger event (start) for each analog output channel.
Amplitude Correction Factor
The Amplitude Correction Factor (CF) consider the deviation of the load and of the channel source resistance
from the nominal 50 Ohm resistance.
Follow the next steps to evaluate the CF:
• Apply to the load a fixed 5 V nominal voltage using the strobe functionality of the selected channel
• Read the voltage load on the multimeter
32
918221 RevA
Advertisement
Table of Contents
