Temporary Error - Fujitsu fi-5900C Getting Started

■ Temporary error

Indication
J0 The paper feeding stopped to protect
jammed paper from damage.
U1 A paper feed error occurred.
U2 A multi feed error occurred.
U4 The ADF cover or the pre-imprinter
cover is opened.
U6 The print cartridge is not set.
U8 One of the following error occurred:
1. The document sensors are dirty.
2. The stacker is full.
3. The Brake roller or Separator rollers
are not installed properly.
The following shows the procedure for releasing of each
of the temporary errors.
• "J0" or "U1" error
1. Remove the document jammed or stopped in
the ADF.
(Refer to the fi-5900C Operator's Guide "6.1
Clearing Document Jams" on the Setup CD-
ROM.)
2. Confirm that the documents meet the paper
specifications for scanning.
(Refer to fi-5900C Operator's Guide "7.2 Doc-
ument Quality" on the Setup CD-ROM.)
• "U2" error
Press the [Send to] button on the Operator Panel.
The documents that were multi fed will be
ejected.
• "U4" error
Close the ADF cover or pre-imprinter cover.
• "U6" error
This is a temporary error related to the Imprinter
option (sold separately). For details, refer to the
"fi-590PRF/ fi-590PRB Operator's Guide, "5
Error Message".
• "U8" error
1. Clean the document sensors
For details refer to fi-5900C Operator's Guide
"4.5 Cleaning the Transport path and the sen-
sors".
2. Verify that the number of sheets ejected to the
stacker is below stacker's capacity, and that
the Pick roller is not set for manual feeding.
3. Verify that the both rollers are installed prop-
erly. For details, refer to fi-5900C Operator's
Guide "5.5 Replacing the Separator Rollers"
and "5.6 Replacing the Brake roller".
Meaning
fi-5900C Image Scanner Getting Started
■ Device alarm (Permanent error)
Indication
E0 Hopper or Stacker error
E2 Optical system error (front)
E3 Optical system error (back)
E4 The motor fuse has blown out.
E5 The lamp fuse has blown out.
E6 Operator panel error
E7 Trouble occurred in the internal memory
(EEPROM).
E8 SCSI fuse has blown out
E9 Image memory error
EA Imprinter error
Image memory error
Ec
Ed SCSI interface or USB interface
controller error
EF Background switching mechanism error
E10 ROM error
E11 Cooling fan error
E12 Heater error
E15 Extended memory error
E16 Option board error
E17 The imprinter fuse has blown out.
E18 Sensor error
E19 LSI error
E1A Troubles occurred in the communication
inside of the scanner.
When you encounter any alarm, turn off and on the
scanner. If the alarm is still displayed on the Function
Number Display, contact the store where you purchased
the scanner or an authorized FUJITSU scanner service
provider.
Meaning
3
AP-