Fujitsu fi-5900C Getting Started page 18

•
Depending on the state of the operating
ATTENTION
system, the computer may shut down
and restart. In this case, the computer
detects the scanner when it starts up.
Do not remove the Setup CD-ROM from
the CD drive until the computer com-
pletely starts up again.
•
Depending on the operating system you
are using, you may need to do the fol-
lowing.
Windows 2000:
If you see the [Digital Signature not
Found] dialog box, click the [Yes]
button.
Windows Vista:
If you see the [Found New Hardware]
dialog box, select [Locate and install
driver software], and then in the [User
Account Control] dialog box, click the
[Continue] button, if it is displayed.
The installation of FUJITSU ISIS is complete.
Next, install ScandAll PRO (
To make sure that FUJITSU ISIS is
ATTENTION
successfully installed, perform a scan with
an ISIS-compliant application such as
ScandAll PRO. For information about how
to scan with ScandAll PRO, refer to
section "2.4 Checking Scanner Driver
Operation" on page
ScandAll PRO ScandAll PRO
■ Installing ScandAll PRO
ScandAll PRO is software for scanning images, which is in
compliance with both TWAN/ISIS standards. Using
FUJITSU TWAIN 32 or FUJITSU ISIS together with
ScandAll PRO allows you to create document images.
Be sure to log on as a user with
ATTENTION
"Administrator" privileges.
1. Insert the Setup CD-ROM into a CD drive.
⇒
<SETUP DISK START UP SCREEN> appears.
2. Click [INSTALL PRODUCTS], and then click
[ScandAll PRO].
3. Select a language for the installation on
[Choose Setup Language] dialog box, and then
click the [OK] button.
10
page 10).
12.
4. Proceed with the installation, following the on-
screen instructions.
5. When the [InstallShield Wizard Complete] dialog
box appears, click the [Finish] button.
For information about the features of
HINT
ScandAll PRO, refer to Help topics in
ScandAll PRO.
Error Recovery Guide
If the Error Recovery Guide is installed on your computer,
you can troubleshoot errors that may occur in the scanner by
simply following the on-screen instructions.
If you did not install the Error Recovery Guide together with
the scanner driver, follow the procedure below to install it.
1. Insert the Setup CD-ROM into the CD drive.
⇒
<SETUP DISK STARTUP SCREEN> appears.
2. Click [INSTALL PRODUCTS], and then click [Error
Recovery Guide].
3. Select a language for the installation in the [Choose
Setup Language] dialog box, and then click the [OK]
button.
4. Install the application, following the on-screen
instructions.
5. When you see the [InstallShield Wizard Complete]
dialog box, click the [Finish] button.
QuickScan Pro™ <Trial Version>
QuickScan Pro™ is image capturing software based on the
ISIS standard. By using this software together with FUJITSU
ISIS, you can scan documents with the scanner. Follow the
procedure below to install the trial version of QuickScan
Pro™ that comes with this scanner.
Be sure to log on as a user with
ATTENTION
"Administrator" privileges.
1. Insert the Setup CD-ROM into a CD drive.
⇒
<SETUP DISK STARTUP SCREEN> appears.
2. Click [INSTALL PRODUCTS], and then click
[QuickScan Pro (Trial)].
3. In the [Welcome to the InstallShield Wizard for
QuickScan 4.5] dialog box, click the [Next] button.