Temporary Error - Fujitsu fi-5950 Getting Started

■ Temporary error

Indication
J0 The paper feeding stopped to protect
jammed paper from damage.
U1 A paper feed error occurred.
U2 A multi feed error occurred.
U4 The ADF cover or the pre-imprinter
cover is opened.
U6 The print cartridge is not set.
U8 One of the following error occurred:
1. The document sensors are dirty.
2. The stacker is full.
3. The Brake roller or Separator rollers
are not installed properly.
The following shows the procedure for releasing of each
of the temporary errors.
• "J0" or "U1" error
1. Remove the document jammed or stopped in
the ADF.
(Refer to the fi-5950 Operator's Guide "6.1
Clearing Document Jams" on the Setup DVD-
ROM.)
2. Confirm that the documents meet the paper
specifications for scanning.
(Refer to fi-5950 Operator's Guide "7.2 Docu-
ment Quality" on the Setup DVD-ROM.)
• "U2" error
Press the [Send to] button on the Operator Panel.
The documents that were multi fed will be
ejected.
• "U4" error
Close the ADF cover or pre-imprinter cover.
• "U6" error
This is a temporary error related to the Imprinter
option (sold separately). For details, refer to the
"fi-590PRF/ fi-590PRB Operator's Guide", "5
Error Message".
• "U8" error
1. Clean the document sensors
For details refer to fi-5950 Operator's Guide
"4.5 Cleaning the Transport path and the sen-
sors".
2. Verify that the number of sheets ejected to the
stacker is below stacker's capacity, and that
the Pick roller is not set for manual feeding.
3. Verify that the both rollers are installed prop-
erly. For details, refer to fi-5950 Operator's
Guide "5.5 Replacing the Separator Rollers"
and "5.6 Replacing the Brake roller".
Meaning
■ Device alarm (Permanent error)
Indication
E0
E2
E3
E4
E5
E6
E7
E8
E9
EA
Ec
Ed
EF
E10
E11
E12
E15
E16
E17
E18
E19
E1A
E1b
When you encounter any alarm, turn off and on the
scanner. If the alarm is still displayed on the Function
Number Display, contact the store where you purchased
the scanner or an authorized FUJITSU scanner service
provider.
AP-3
Meaning
Hopper or Stacker error
Optical system error (front)
Optical system error (back)
The motor fuse has blown out.
The lamp fuse has blown out.
Operator panel error
Trouble occurred in the internal memory
(EEPROM).
SCSI fuse has blown out
Image memory error
Imprinter error
Image memory error
SCSI interface or USB interface
controller error
Background switching mechanism error
ROM error
Cooling fan error
Heater error
Extended memory error
Option board error
The imprinter fuse has blown out.
Sensor error
LSI error
Troubles occurred in the communication
inside of the scanner.
5-volt fuse has blown out.