Oki MC860 Easy Setup Manual page 6

Click [Settings].
Check the "Outgoing Mail Server" screen to fill in
"E-7" and "E-8" on the Setup Information Form.
• If [Use the same settings as the incoming mail
server] is checked, Enter the same contents as
"E-9" and "E-10" in "E-7" and "E-8".
• If [Log on by the following account and password]
is checked, enter [Account name] in "E-7" and a
password in "E-8".
2-1-2 Check [From](the email address used by MC860).
Enter an email address used by MC860 in "E-1" on the Setup Information Form.
If this email address is specified by the network administrator, enter the email address.
If ADSL, or the like is used, obtain an email address from your provider.
If any email address is not specified or obtained:
If the "E-6" authentication method is "SMTP", fill in an arbitrary name in "E-1".
•
e.g.: mc860@test.co.jp
If the "E-6" authentication method is "POP", enter the same name as "E-12" in "E-1".
•
Notes:
• If the [From](mail address) is not set in MC860, an error will occur in the mail server at the
email transmission, and it will not be transmitted.
• When an email is received by the MC860, make sure to obtain an email address from the
network administrator or your provider.
Click the [Advanced] tab to fill in each column
on the Setup Information Form according to the
following figure.

Fill in "E-4".
Fill in "E-5".