Input Adjust Control; Deinterlacing 8; Overscan 8; Line Offset 8 - DVDO iScan VP20 Owner's Manual

The ten user-defined preset value selections (Preset 1 - 10) are stored in non-volatile memory and
are always available.
Each of these presets consists of the following:
• Zoom parameter
• pan parameter
• borders
The User preset selection is also stored in non-volatile memory.
always updated after you modify any pre-defined aspect ratio setting. In order to permanently keep a
custom aspect ratio setting, you must save it to one of the four preset selections.
Setting the Input Aspect Ratio Manually
You can set the following parameters manually:
• Zoom factor
• pan parameter
• Borders (horizontal and vertical)
Save User-defined presets as follows:
• Customize the aspect ratio manually (refer to Setting the Input Aspect Ratio Manually above).
• Select one of the presets from the 'Save User To' menu. Confirm the action by selecting Yes.
• There are 10 user-definable presets available.
NOTE: Be careful, because saving to a preset deletes the previous preset.
If you have not customized the aspect ratio, and the current aspect ratio settings are the same as a
system defined preset. In this case, the system will not allow you to save the preset setting.

Input Adjust Control

Push the Input Adjust button once to show the current input adjustment function. You can cycle
through the available functions by pushing this button repeatedly.
The available 'input adjust' functions are as follows:
• deinterlacing
• overscan
• line offset
• Color space
• input level
• VCr mode
• HDMI Config
• auto priority
• audio input
• aV lip sync
7
However the User selection is