Related Manuals for Clarke CAT 52
Summary of Contents for Clarke CAT 52
- Page 1 4” ANGLE GRINDER 4” ANGLE GRINDER MODEL NO: CAT 52 PART No: 3110685 OPERATION & MAINTENANCE INSTRUCTIONS 0807...
-
Page 2: Specifications
Weight: ............3.1 lbs Please note that the details and specifications contained herein are correct at the time of going to print. However CLARKE International reserve the right to change specifications at any time without prior notice. Always consult the machines data plate... - Page 3 Service@clarkeinternational.com ACCESSORIES A wide range of Airline accessories is available, including Filter/Regulators, Lubricators, High Pressure Hoses from 5 to 100 Metres, etc. Contact your CLARKE dealer for further information, or CLARKE International Sales Department on 01992 565300 - 2 -...
-
Page 4: Safety Precautions
SAFETY PRECAUTIONS AIR SUPPLY IMPORTANT Tools of this type, operate on a wide range of air pressures. It is recommended that air Failure to follow these precautions could pressure to this tool does not exceed 90 PSI result in personal injury, and/or damage to property. -
Page 5: Maintenance
If the grinder is to be stored, or is idle for longer both wrenches firmly and tighten in than 24 hours, run a few drops of Clarke Air clockwise direction. Remove wrenches. Line Oil into the air inlet, and run the tool for 5 4. -
Page 6: Parts Diagram
PARTS DIAGRAM PARTS LIST Part No. Description Qty No. Part No. Description AG-30001 Exhaust Deflector AG-40034 Motor Housing AG-30003 Inlet AG-30036 Motor Housing Shield AG-30005 Motor Lock Nut WW-0010 Wave Washer AG-30006 Muffler Felt BB-06252 Ball Bearing AG-30007 Throttle Lever Pin AG-30039 Bearing Spacer AG-30008...