Ac Wiring - Xantrex RV2012GS Owner's Manual

DC +
DC Negative Grounding Bus
DC Fuse
Battery Temperature
Sensor
House Battery
Alternator
Figure 2-1 RV Electrical System Diagram

AC Wiring

Overview
975-0209-01-01
DC Load Center
Grounding (Bonding) Bus
DC Positive Bus
+
DC -
Isolator
Non-Inverter Loads
Generator
Important:
Figure 2-1 does not show all required grounding or over-current protection.
The U.S. National Electrical Code (NEC) defines the standards for AC and DC
installation wiring in RV applications, but there are still many installation
variables. Most are determined by the level of automatic switching desired and the
amount of external AC power to be switched.
Installation should be done by a qualified electrician. Consult local code for the
proper wire sizes, connectors and conduit.
The AC and DC terminals are located on the same end of the chassis as the status
LED and power switch. A six station terminal block is provided to connect the AC
input and AC output. All terminals are labeled on the inverter. Consult your local
code for proper wire sizes, connectors, conduit, and so on. See Table 2-1 for
minimum recommended wire sizing. Code requires that an external disconnect
switch be used in the AC input wiring circuit. The AC breakers in a sub panel will
meet this requirement.
RV Series Inverter/Charger
30
30A
60A
AC Out
AC In
AC Main Panel
Transfer Switch UtilityPower
Wiring the Inverter/Charger
RC/GS Remote
/
Engine Negative Terminal
Engine Battery
RESET
ESET R
TEST
TEST
GFCI
Inverter AC Panel
Sensing and control
2–5