Sleep Operation - Haier HSM18HEKC03/R2 Service Manual

Operation

Sleep Operation

Before going to bed,you can simply press the SLEEP
button and unit will operate in SLEEP mode and bring
you a sound sleep.
Use of SLEEP function
After the unit starts,set the operation status,then press
SLEEP button before which the clock must be adjudted
and time being set.
Operation Mode
1. In COOL,DRY mode
1 hours after SLEEP mode starts,temp.will become
higher than temp.setting.After another 1 hours,temp.rises
by 1 O C futher.The unit will run for further 6 hours then stops
Temp. is higher than temp.setting so that room temperature
won't be too low for your sleep.
SLEEP operation starts
1 hr
Rises 1
1 hr
Temp.setting
In COOL, DRY mode
In HEAT mode
2.
1 hours after SLEEP mode starts,temp will become 2
lower than temp.setting.After another 1 hours,temp
O
decrease by 2 C futher.After more another 3 hours,temp.
O
C
rises by 1 futher.The unit will run for further 3 hours then
stops.Temp.is lower than temp. setting so that room
temperature won't be too high for your sleep.
Temp.setting
1 hr
Decreases 2
1 hr
Decreases 2
3 hrs
SLEEP
operation starts
In HEAT mode
In AUTO mode
3.
The unit operaters in corresponding sleep mode
adapted to the automatically selected operation mode.
HSM18HEKC/HRAC03/R2(DB) HUM18HC03/R2(DB) -SM
SLEEP operation stops
Approx.6hrs
O
Rises 1 C
O
C
Unit stop
Unit stop
O C
O C
3 hrs
O
Rises 1 C
SLEEP
operation stops
4. In FAN mode
It has no SLEEP function.
5.Set the wind speed change when sleeping
If the wind speed is high or middle before setting for the
sleep, set for lowing the wind speed after sleeping.
If it is low wind, no change.
Note
When TIMER function is set, the sleeping function can't be
set up .After the sleeping function is set up
TIMER function, the sleeping function will be cancelled; the
machine will be in the state of timing-on.
POWER/SOFT Operation
(1)
POWER Operation
When you need rapid heating or cooling, you can use this
function. In COOL mode, fan speed automatically takes
high speed of AUTO fan mode. In HEAT mode, fan speed
1 O
C automatically takes medial speed of AUTO fan mode.
(2)
SOFT Operation
You can use this function when silence is needed for rest or reading.
In SOFT operation mode, fan speed automatically takes low speed
of AUTO fan mode.
Note
During POWER operation, in rapid HEAT or COOL
mode , the room will show inhomogeneous temperature
distribution. Long period SOFT operation will cause
effect of not too cool or not too warm.
To cancel POWER or SOFT operation
Press POWER/SOFT button again ,POWER or SOFT
disappears.
HEALTH
O
C
Healthy Negative ions
The anion generator in the airconditioner can generate a lot
of anion effectively balance the quantity of position and anion
in the air and also to kill bacteria and speed up the dust
the room and finally clean the air in the room.
sediment in
About UV light degerming function
UV light emitted by the UV light device of the indoor unit
catalytically activates the nano TiO
touching intermediary, and the degerming effect is highly
efficient and lasting.
Note: when the function is running, don't open the inlet grille.
43
,
if user resets
Operation
on the multi-lights
2