Related Manuals for Haier HSM12HEKC03
Summary of Contents for Haier HSM12HEKC03
-
Page 1: Table Of Contents
SPLIT TYPE ROOM AIR CONDITIONER OPERATION MANUAL Contents PARTS AND FUNCTIONS OPERATION INDOOR UNIT INSTALLAION MAINTENANCE CAUTIONS TROUBLE SHOOTING ● Please read this operation manual before using the air conditioner. Keep this operation manual for future reference. 00105... -
Page 2: Parts And Functions
If the remote controller can't run normally during operation, please CLOCK reload several minutes later. remove the batteries and LIGHT SLEEP Hint: LOCK RESET Remove the batteries in case won't be in use for a long period. If there is any display after taking-out, just press reset key. -
Page 3: Operation
AUTO HEAT LOCK RESET It is impossible to change the settings of temp. and fan speed,It is also not possible to operate in timer or dry mode. 1. Unit start Test operation: Press ON/OFF on the remote controller, unit starts. -
Page 4: Sleep Operation
AUTO fan mode. In COOL, DRY mode In HEAT mode SOFT Operation You can use this function when silence is needed for rest or reading. 1 hours after SLEEP mode starts,temp will automatically takes low speed In SOFT operation mode, fan speed become 2 lower than temp.setting.After... - Page 5 - Low Voltage Directive 2006/95/EC on the refrigerant charge label supplied with the product. -Electomagnetic CompatibilitY 89/336/EEC The filled out label must be adhered in the proximity of the -Electomagnetic CompatibilitY 2004/108/EC product charging port (e.g. onto the inside of the stop value ROHS cover).
-
Page 6: Indoor Unit Installaion
Rear more than Left right 10cm Right Below more than 10cm The distance between the indoor unit and the floor should be more than 2m. Please be subject to the actual product purchased,the above picture is just for your reference. -
Page 7: Indoor Unit Installation
Left-rear piping ] Remove terminal cover at right bottom corner of In case of left side piping, cut away, with a nipper, the lid for left piping. indoor unit, then take off wiring cover by removing In case of left-rear piping, bend the pipes according to the piping its screws. - Page 8 When connecting the cable before installing the indoor unit Please don’t do the drainage as shown below. Insert the cable from the back side of the unit, then pull it out on the front side. Loosen the screws and insert the cable ends fully into terminal block, then Less than tighten the screws.
-
Page 9: Maintenance
If the unit is not to be used Use the louvers effectively Use a vacuum cleaner to remove dust, or wash the filter with for a long time, turn off the water.After washing, dry the filter completely in the shade. -
Page 10: Cautions
Cautions WARNING Please call Sales/Service Shop for the Installation. Do not attempt to install the air conditioner by yourself because improper works may cause electric shock, fire, water leakage. WARNING Check proper When abnormality such as burnt-small found, Use an exclusive... -
Page 11: Trouble Shooting
Outdoor filter may be too dirty. Minimum:D.B (INVERTER) This is because the system 2. If the power supply cord is damaged, it must be replaced by the circulates smells from the interior Smells are generated. air such as the smell of furniture,...