Electronic Equipment, at a recognised disposal facility. CONTENTS When unpacking, check for damage and /or shortages etc. Any found should be reported to your CLARKE dealer where the appliance was origi- nally purchased. This CEW1000 Impact Wrench is delivered supplied with the following components: •...
GENERAL SAFETY RULES WORK AREA 1. Keep the work area clean and well lit. Cluttered and dark areas invite accidents. 2. Do not operate power tools in explosive atmospheres such as in the presence of flammable liquids, gasses or dust. Power tools create sparks which may ignite dust or fumes.
Page 5
6. Dress properly. Do not wear loose clothing or jewellery which may get caught in moving parts. Wear protective hair covering to contain long hair. For best footing, wear rubber soled footwear. Keep floor clear of oil, scrap wood, etc. 7 Concentrate on the job in hand, no matter how trivial it may seem.
IMPACT WRENCH SAFETY INSTRUCTIONS 1. Use the wrench correctly. Only use the impact wrench in the manner and for the functions described in these instructions. 2. Changing Sockets. Always disconnect the machine from the power supply when changing sockets etc. Use only Impact Wrench sockets..DO NOT use standard sockets.
3. Should you wish to replace a detachable fuse carrier, ensure that the correct replacement is used (as indicated by marking or colour code). 4. Replacement fuse covers can be obtained from your local Clarke dealer or most electrical stockists.
OVERVIEW The CLARKE CEW1000 Impact Wrench is equipped with a 3-position Forward/ Reverse/Neutral trigger switch (item 4 below). When trigger is squeezed downwards, rotation is forward (clockwise). When squeezed upwards, rota- tion is reversed (anti-clockwise), and when in the centre position the tool is stopped.
OPERATING INSTRUCTIONS ALWAYS ENSURE THAT THE MACHINE IS DISCONNECTED FROM THE POWER SUPPLY BEFORE CHANGING THE SOCKET. LOOSENING A NUT 1. Remove any wheel trim, before selecting the appropriate socket and placing firmly on the square drive of the wrench. 2.
• Ensure all nuts, bolts and screws remain tight to ensure the machine is in safe working condition. • Refer to your CLARKE dealer if internal maintenance is required. • Check the power cable to ensure it is sound and free from cracks, bare wires etc.
Check to ensure the fuse is sound and replace if necessary. If the fuse is sound or blows repeatedly, consult your CLARKE dealer. EXCESSIVE SPARKING OCCURS This indicates worn brushes. This problem is quickly remedied by replacing the brushes as page 10, or alternatively consult your CLARKE dealer for their replacement.
Page 12
SPARE PARTS LIST c i t l l o l l a l l a c t i - l l / e l t - r...
TECHNICAL SPECIFICATION Please note that the details and specifications contained herein, are correct at the time of going to print. However, CLARKE International reserve the right to change specifications at any time without prior notice. Always consult the machine’s data plate.
‘K’, which represents the uncertainty factor, i.e. a value in excess of ‘a’, to which the tool could vibrate under normal conditions. These values appear in the specification panel below. MODEL No: CEW1000 DESCRIPTION: 1000W IMPACT WRENCH Declared vibration emission value in accordance...
Page 16
You will note that a third value is given in the specification - the highest measured reading in a single plane. This is the maximum level of vibration measured during testing in one of the axes, and this should also be taken into account when making a risk assessment.
The CE mark was first applied in: 2008 Product Description: Electric Impact Wrench (1000W) Model number(s): CEW1000 Serial / batch Number: Current Manufacture. Date of Issue: 15/07/2008 Signed A.C. AIKEN Senior Manager Clarke International. 07-0878 impact wrench RV1.doc Page 1 of 1...