How To Operate; How To Move - Matrix KranKcycle User Manual

4.2 HOW TO OPERATE
!WARNING! Do not operate this cycle with 2 people, equipment is
designed for individual use. Please stay clear of moving parts and place
both hands on the crank handles while exercising. Stop your workout in the
event a person is within reach of moving parts.
Recommended cadence while exercising should be 60-90 RPM and the
user should never operate without resistance applied.
RESISTANCE ADJUSTMENT
The preferred level of difficulty in Kranking (resistance) can be regulated in
fine increments by use of the resistance knob. To increase the resistance,
turn the resistance knob toward the "+" sign; to decrease the resistance,
turn the knob toward the "- " sign.
IMPORTANT
: To stop the flywheel
(wheel) while Kranking, turn the
resistance knob toward the "+" sign
.
until flywheel stops
!WARNING!
The flywheel will
continue to move even after you
stop Kranking. Always Krank in a
controlled manner and adjust your
desired cadence and resistance
according to your own abilities.
11
Krankcycle_091021.indd 11
CHAPTER 4: u t
sinG he
CHANGE CRANK ARM DIRECTION
To bring cranking direction from forward or reverse, bring crank arms to top
position, release rotation level, turn drive frame 180º and lock rotation lever
back into place (toward the word lock) and pivot crank arms back toward user.
STEP 1
STEP 3
STEP 5
!WARNING!
Kranking. Make sure that no components or devices block the users movement.
4.3 HOW TO MOVE
Bend your knees and lift the rear base of the KRANKcycle™ using the
integrated grips on each side of the base. Carefully move the cycle to the
desired location and then lower it. CAUTION: To reduce the risk of injury,
use extreme caution while moving the KRANKcycle™. Do not attempt to
move it over uneven surfaces and make sure you allow for a minimum of 20
inches to the nearest equipment. When lifting the front of the unit, grab the
metal frame only – not the plastic base.
If the KRANKcycle™ rocks on the floor after being set down, turn the
leveling feet (see diagram) underneath the front stabilizer until the rocking
motion is eliminated.
IMPORTANT
!WARNING!
properly leveled before use.
KranK
™
cycle
STEP 2
STEP 4
STEP 6
Make sure rotation adjustment lever is locked before you begin
: Please do not unscrew the leveling feet more than ½ inch!
The KRANKcycle should be installed on a stable base and
LOCKED
10/22/09 8:31 AM