To Add A User - Honeywell ADEMCO VISTA-120 User Manual

Security Codes & Authority Levels (cont'd)

To Add a User

IMPORTANT: Temporary users should not be shown how to use any system
function they do not need to know (e.g. bypassing protection zones).
1. Enter Master or Manager code and press the
2. Enter the new user's 3-digit User Number (002-150).
3. Enter 4-digit security code for that user. The following prompts will
appear.
ADD NEW USER?
0 = NO , 1 = YES
USER NUMBER = 003
ENTER AUTH. LEVEL
ACCESS GROUP?
ENTER 0-8
RF BUTTON ?
0 = NO , 1 = YES
ENTER BUTTON ZN #
(001-128)
MULTI-ACCESS ?
0 = NO , 1 = YES
– 18 –
Enter 1 to add a new user code. Entering 0 will
change the existing user's code to the code entered
in step 3. See Changing A User's Code section.
Enter the authority level, 1-6, for this user within
this partition.
1=master 2=manager
4=operator B 5=operator C
If access schedules have been programmed, this
prompt appears. Enter the user's access group
number (1-8) if this user should have limited
access to the system. Enter 0 if no access group
should be assigned.
This prompt will appear if a 5800 series button
transmitter has been supplied and has not yet been
assigned to a user. Press 1 if a button transmitter
will be assigned to this user. Otherwise press 0.
If assigning a button transmitter, this prompt will
appear. Enter the button's zone number (see your
installer for zone number).
If you as a user have access to other partitions, the
keypad will prompt for ability of this new user to
access (GOTO) those partitions. Press 0 (NO) or 1
(YES). If no, the system activates this user code and
exits "Add a User" mode. If yes, the keypad prompts
for the Global Arm option for this user.
CODE
8 key.
3=operator A
6=duress code