1
Repairing the 1800
Disconnecting the Cable
The 1800 uses either the old standard cable boot or the new easy-to-use boot. All cables
marked Rev: 10 or higher use the new boot, while all cables marked Rev: 09 or lower
use the old boot.
Caution
Do not attempt to remove the cable without following the correct procedure for the
boot type, or you will damage the shell of the 1800.
To remove cables marked Rev. 10 or higher
1. Holding the 1800, press the upper part of the cable boot with your thumb and slide
the cable boot away from the 1800.
1800M007.eps
2. Disconnect the connector from the 1800.
1800M009.eps
1-5
Need help?
Do you have a question about the ScanPlus 1800ST and is the answer not in the manual?